Difference between revisions of "Power Button For RPi SKU: EP-0077"

From 52Pi Wiki
Jump to navigation Jump to search
(Power Button For RPi)
(Power Button For RPi)
Line 1: Line 1:
 
=Power Button For RPi=
 
=Power Button For RPi=
 +
[[File:8182.JPG|left|500px]]
 +
<br style="clear:both;">
 +
----
 
{|
 
{|
|[[File:8182.JPG|left|300px]]
+
|[[File:Pwr2.jpg|left|500px]]
|[[File:Pwr2.jpg|none|300px]]
+
|[[File:Pwr3.JPG|none|500px]]
|[[File:Pwr3.JPG|none|300px]]
 
 
|}
 
|}
 
<br style="clear:both;">
 
<br style="clear:both;">

Revision as of 14:26, 15 February 2017

Power Button For RPi

8182.JPG



Pwr2.jpg
Pwr3.JPG



Description

As everyone at some point will recognize the Raspberry Pi doesn't include any kind of shutdown button.
So the only way to power it off is by unplugging it from the power supply.
To make sure you get no corruption of your data files on the SD card you should shutdown the Raspberry before powering it off.
So the whole procedure can be a bit annoying especially if you want to use the Raspberry as some kind of embedded PC .
e.g. a media server or an internet radio.


Features

Power Button provides a small circuit that includes the features:

  • Sending a shutdown signal to the Raspberry if the Shutdown Button is pressed
  • Waiting for the Raspberry to shut down
  • Powering off the Raspberry after save shutdown
  • Powering on the Raspberry after the Button is pressed again
  • LED light indicating the current state: On / Shutdown / Off
  • Easy to setup

Dimension

Parameter Value
Dimension 65mm x 30 mm x 20mm
Weight 22.72g

Package Includes

  • Power Button For RPi Module x1
  • IR Remote controller ( without battery) x1

Mechanical Drawing

Pwr6.jpg



Parameters

There is a chart which can show you the function of the GPIO Pin definition of this board:

Function BCM RPi
Disk Status 21 Pin 40
Shut Down 24 Pin 18
PWR Status 26 Pin 37
GND N/A Pin 6/9/14/20/25/30/34/39
5V 5V Pin 2/4
NOTE: Please make sure that your Raspberry Pi  have  5V/2.5A  power supply with this module!!!

How to wire it up

Do NOT connect your power supply to Raspberry Pi,  Please connect it to Power Button directly.
Pwr4.JPG
Pwr5.JPG



How to set it up

  • 1. Remove your TF card and connect it to your PC or laptop with TF card adapter.
  • 2. Modify /boot/config.txt file as following:
device_tree=bcm2710-rpi-3-b.dtb
dtoverlay=power-off,gpiopin=26
dtoverlay=pi3-act-led,gpio=21
  • 3. Download shell script:
apt-get install -y wiringPi
cd ~
git clone https://github.com/yoyojacky/powerbuttom.git
cd ~/powerbuttom
sudo mv ~/powerbuttom/gpioshutdown /etc/init.d/
sudo chmod +x /etc/init.d/gpioshutdown
sudo vim.tiny /etc/rc.local

Add this two lines before exit 0

gpio mode 25 out
gpio write 25 1
  • 4. Reboot your Raspberry Pi and plug power button on your RPi, press the button to test.

Have fun.