EXB EoF-002: Difference between revisions
Jump to navigation
Jump to search
mounted on Raspberry Pi
in the night
(→购买链接) |
(→附件) |
||
Line 29: | Line 29: | ||
<br>Just insert the module to Raspberry Pi, like the below picture: | <br>Just insert the module to Raspberry Pi, like the below picture: | ||
<br>[[Image:122.jpg|900px]] | <br>[[Image:122.jpg|900px]] | ||
Revision as of 15:03, 23 September 2016
Raspberry Pi Expansion Board
Description
This GPIO Prototyping Board is Designed for Raspberry Pi B+ and Pi 2 . you can combine your raspberry pi with other components, modules in this board .it's very convenient
Produce Features
- A big prototyping area, half of which is 'breadboard' style and half of which is 'perfboard' style so you can wire up DIP chips, sensors, and the like.
- Along the edges of the proto area, all the GPIO/I2C/SPI and power pins are broken out to 0.1" stips so you can easily connect to them.
- On the edges of the prototyping area, all of the breakout pins are also connected to labeled 3.5mm screw-terminal blocks. This makes it easy to semi-permanently wire in sensors, LEDs, etc.
- There's also a 4-block terminal block broken out to 0.1" pads for general non-GPIO wiring.
- A SOIC and a TSSOP surface mount chip breakout area, for those chips that dont come in DIP format.
- EEPROM for Raspberry Pi HAT
- POWER LED indicator
Overview
File:P14.JPGFile:P13.JPGFile:P15.JPG
File:P5.JPGFile:P4.JPGFile:P2.JPG
File:P12.JPGFile:P10.JPGFile:P11.JPG
product scale
schematic
File:Expansion board schematic.png
mounting introduction
Just insert the module to Raspberry Pi, like the below picture:
File:122.jpg