EP-0100
UPS for Raspberry Pi 3B/3B Plus
This is an uninterruptible power supply for the Raspberry Pi.
It provides enough power for the Raspberry Pi to make your Raspberry Pi still work while moving,
and its design is so smart that you can get rid of troubled of a mass wire.
This UPS can provide you with the operation of replacing the battery yourself.
It can use most of the 18650 standard batteries and fully comply with the battery characteristics in terms of battery life.
In addition, the power display provided on the circuit board is also very user-friendly.
The illuminated LED light can quickly show the remain power and support the discharging while charging.
You can directly connect to the external power supply for charging.
At the same time, the Raspberry Pi will not be turned off.
Caution
Warning!
This product belongs to the power supply device. Please keep it out of the reach of children. Please strictly refer to the instructions for the UPS product. If the battery polarity is reversed, it will directly burn the power management chip of the device and even cause fire or personal injury. Do not add any Components by yourself, all accidental damage caused by the cause is at your own risk.
Features
- LED remaining battery prompt
- Contact type power supply
- Replaceable battery solution
- Advanced power management chip
- Charge and discharge management separately
- Support Raspberry Pi 3B/3B+
- 18650 power solution
- 4.85v/1.7A ≈ 8.25W output capability
- Two USBA port power output
- Output overcurrent protection
- Thimble output, to avoid occupying GPIO-
- Tap to boot, long press to shut down
- Support the charge and discharge power display
- The battery holder can be quickly replaced
Gallery
Mechanical Drawing
How to setup
LED light status definition
- Discharge Status
Power C(%) | LED1 | LED2 | LED3 | LED4 |
---|---|---|---|---|
C >= 75% | ON | ON | ON | ON |
50% <= C <75% | ON | ON | ON | OFF |
25% <= C <50% | ON | ON | OFF | OFF |
3% <= C < 25% | ON | OFF | OFF | OFF |
0% <= C < 3% | 1.5Hz Blink | OFF | OFF | OFF |
- Charging Status
Power C(%) | LED1 | LED2 | LED3 | LED4 |
---|---|---|---|---|
100% | ON | ON | ON | ON |
75% <= C | ON | ON | ON | 1.5Hz Blink |
50% <= C <75% | ON | ON | 1.5Hz Blink | OFF |
25% <= C < 50% | ON | 1.5Hz Blink | OFF | OFF |
C < 25% | 1.5Hz Shining | OFF | OFF | OFF |
Package include
- 1* UPS for Raspberry Pi 3B/3B Plus
- 4* M2.5* copper stick
- 4* M2.5 screws
- 4* M2.5* long copper stick
- 4* M2.5 nuts
- 1* Acrylic shield
- 1* Instuctions
Keywords
- battery, 18650, lipo battery, UPS, current, power supply