|
|
| (2 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| =X600 EXPANSION BOARD=
| | |
| [[File:X600 860p 2.jpg|left|300px]]
| |
| ----
| |
| ==Features==
| |
| {| class="wikitable"
| |
| ! Parameter !! Value
| |
| |-
| |
| |Input Voltage || 6V to 20Vdc converted to 5V, 3A via step-down DC/DC converter to power the Raspberry Pi and SATA device
| |
| |-
| |
| |Audio & Video ||
| |
| - Allows you to extract audio signals from HDMI of your Raspberry Pi
| |
| - Converts HDMI audio to digital optical or Coaxial or stereo RCA analog
| |
| - The SPDIF optical or Coaxial audio output supports all audio formats up to 5.1CH Dolby Digital 5.1CH / AC3 &
| |
| DTS 5.1CH audio
| |
| - Extract digital 2CH PCM stereo audio signal from the HDMI input and convert it to 2CH analog stereo output
| |
| through its RCA style L/R analog output or earphone jack
| |
| - Provides the Best Flexibility through Three NEW Audio EDID Settings: Pass, 2CH and 5.1CH
| |
| - Maintains surround format when converting to digital optical audio
| |
|
| |
| - Supports high definition input up to 1080p@(24/60)Hz, output resolution follows input
| |
| - Supports HDMI signal amplification and equalization output for repeater function
| |
| - HDMI output supports all audio formats including more advanced Dolby Digital Plus, PCM5.1CH and beyond
| |
| |-
| |
| |SATA || Allows you to connect SATA devices to your Raspberry Pi
| |
| |-
| |
| |Wireless || Built in IR sensor (38KHz)
| |
| |-
| |
| |Misc ||
| |
| - Power output socket
| |
| - Directly connected on top of the Raspberry Pi using the board GPIO header pins
| |
| - No wiring nor soldering is required
| |
| - Duplicated the 40-pin header of the R-Pi in order to support existing expansion boards
| |
| - Suitable for Raspberry Pi Model B+, Raspberry pi 2 Model B and Raspberry Pi 3 Model B NEW!
| |
| |-
| |
| |Dimensions || 85 x 56mm (Same size as Raspberry Pi)
| |
| |}
| |
| <pre>
| |
| Notes
| |
| 1. The RCA L/R output will not have sound if the incoming audio is multi-channel audio (>2CH). Set EDID switch to 2CH for RCA L/T stereo application.
| |
| 2. TOSLINK optical audio output does not support Dolby Digital Plus (used by Roku and Chromecast) and higher formats, such as HD audio (Dolby TrueHD, DTS-HD Master Audio, PCM5.1 and beyond).
| |
| 3. Set audio EDID to 5.1CH for DD5.1CH / DTS5.1CH, use optical output to connect to audio receiver for surround sound.
| |
| </pre>
| |
