Z-0144

Raspberry Pi 3B Overlay Application Kit

This Kit contains a lot of new sensors such as chart below which can support DT (Device Tree) overlay modules in the newest operating system:

Id	Product Name	Quantity
1	IR receiver	1
2	IR sender	1
3	0.96-inch OLED display	1
4	9g Servo	2
5	VGA666 Module	1
6	PCA9685 Servo driver board	1
7	DHT11 temperature and humidity sensor	1
8	USB-GPS module (with wire)	1
9	Bmp180 barometer module	1
10	Breadboard (middle size)	1
11	Buzzer	1
12	RPI B+ T-Cobbler	1
13	GPIO Extend Board	1
14	Acrylic experimental platform (large)	1
15	Exquisite components box	1

---

Documentation:

Id	Application Note
1	How to use 1 GPIO Pin to drive RaspberryPi Power-on-off-status light
2	How to use 1 GPIO Pin to drive RaspberryPi Disk-Status light
3	How to use VGA666 module to connect RaspberryPi to display
4	How to use BMP085 Barometer to detect pressure
5	How to use IR device to remote control alarm buzzer
6	How to use enc28j60 network interface card as a GPIO NIC
7	How to drive servo by using PCA9685 servo driver board
8	How to use RTC module to provice an stable clock to RaspberryPi
9	How to use LM75 Thermometer module detect the temperature in the room
10	How to use GPS module for real-time location and PPS clock synchronization service
11	How to use GPIO drive servo directly
12	How to use 0.96 Inch OLED Display to display system information
13	13.How to use DHT11 temperature sensor to detect the temperature in the room

---