Z-0144: Difference between revisions
Jump to navigation
Jump to search
Line 55: | Line 55: | ||
| 7 || How to drive servo by using PCA9685 servo driver board | | 7 || How to drive servo by using PCA9685 servo driver board | ||
|- | |- | ||
| 8 || How to use RTC module to | | 8 || How to use RTC module to work as stable clock on RaspberryPi | ||
|- | |- | ||
| 9 || How to use LM75 Thermometer module detect the temperature in the room | | 9 || How to use LM75 Thermometer module to detect the temperature in the room | ||
|- | |- | ||
| 10 || How to use GPS module for real-time location and PPS clock synchronization service | | 10 || How to use GPS module for real-time location and PPS clock synchronization service |
Revision as of 11:10, 30 August 2016
Raspberry Pi 3B Overlay Application Kit
This Kit contains a lot of new sensors such as chart below which can support DT (Device Tree) overlay modules in the newest operating system:
Id | Product Name | Quantity |
---|---|---|
1 | IR receiver | 1 |
2 | IR sender | 1 |
3 | 0.96-inch OLED display | 1 |
4 | 9g Servo | 2 |
5 | VGA666 Module | 1 |
6 | PCA9685 Servo driver board | 1 |
7 | DHT11 temperature and humidity sensor | 1 |
8 | USB-GPS module (with wire) | 1 |
9 | Bmp180 barometer module | 1 |
10 | Breadboard (middle size) | 1 |
11 | Buzzer | 1 |
12 | RPI B+ T-Cobbler | 1 |
13 | GPIO Extend Board | 1 |
14 | Acrylic experimental platform (large) | 1 |
15 | Exquisite components box | 1 |
Documentation:
Id | Application Note |
---|---|
1 | How to use 1 GPIO Pin to drive RaspberryPi Power-on-off-status light |
2 | How to use 1 GPIO Pin to drive RaspberryPi Disk-Status light |
3 | How to use VGA666 module to connect RaspberryPi to display |
4 | How to use BMP085 Barometer to detect pressure |
5 | How to use IR device to remote control alarm buzzer |
6 | How to use enc28j60 network interface card as a GPIO NIC |
7 | How to drive servo by using PCA9685 servo driver board |
8 | How to use RTC module to work as stable clock on RaspberryPi |
9 | How to use LM75 Thermometer module to detect the temperature in the room |
10 | How to use GPS module for real-time location and PPS clock synchronization service |
11 | How to use GPIO drive servo directly |
12 | How to use 0.96 Inch OLED Display to display system information |
13 | 13.How to use DHT11 temperature sensor to detect the temperature in the room |